shutterstock_315608027

How to Fix Your Leaking Pipes | Russell & Lemay | Little Rock AR

Every homeowner dreads water leaks. Regardless of how small a water leak is, urgent attention to the pipe is quite indispensable. Once you notice water drips along your walls near the plumbing joints, don’t just ignore them. The longer the leaks are left unattended, the griever the consequences a homeowner faces.

What causes pipes to leak?

  • Corrosion

When pipes corrode, they become weak and cannot hold much water, which gradually results to pipe leaks. If not checked by a licensed plumber, the issue would only get worse. Pipe corrosions are caused by chemical reactions between the pipes and chemical substances in the waste. Old pipes are also susceptible to corrosion. To help avoid water leaks, consider replacing all your old pipes. When buying the pipes, ask your plumber to which pipe quality can resist corrosion for long.

  • Too much water pressure

If your plumber did not do his job correctly, water pressure might exceed the pipes’ capacity, causing them to burst. To help prevent the pipe bursts, instruct your plumber to install a pressure regulator. Check it regularly to ensure it is working.

  • Clogs

Do you drain solid substances off the pipes? Did you know they could get stuck or accumulate, making it hard for water to pass through the pipes? How dangerous is this? Once the clogs accumulate inside the pipes, water pressure increases to cover up for the volume of water constrained to move. The pressure may be too much and cause small bursts, which cause leaks in plumbing joints. If you notice that water is moving slower in your taps, that’s enough red flag raised. Call a plumber to check out if your pipes have been clogged up. To avoid clog cases, avoid throwing pieces of clothing, hair, greases and hard kitchen substances in the sinks.

  • Poor plumbing skills

Don’t just pick a plumber because he’s cheap or he has promised excellent services. Check out for their licenses and if possible, ask for references. Poor plumbing services can cost you much in future. An unqualified plumber could use the wrong materials, fail to tighten the joints correctly, or they could just cause another problem without noticing.

How to fix a leaking pipe

When you notice water leaks at plumbing joints, don’t hesitate to fix it. Fixing a leaking pipe is a DIY task. Here are steps to take:

  • Turn off water outlets letting water to pass through the joint to repair.
  • To unscrew the fittings at the joints, cut one side of the leaking joint, at least an inch away.
  • Use pliers or wrenches to disconnect the leaking joints. While holding one side of the fitting tightly, turn the other side anti-clockwise until both pieces separate.
  • Use a wire brush to clean the fitting’s threads. Cleaning helps remove corrosion, clogs stuck on the pipe walls and debris. The male fitting is cleaned best using a standard wire brush while a wire bottlebrush suits the female piece best.
  • Wrap the male threads with a Teflon tape. Thread tapes last longer than joint compounds.
  • Tighten the female fitting against the male fitting until they snug. Be careful not to cause a burst from a too-tight fitting.
  • Use a coupling to reconnect the pipes appropriately. When through, turn on water supply to test if there are any leaks.

If you’re looking for a professional plumbing contractor in Little Rock, Russell and LeMay is your unmatched plumbing partner. Our contractors have been in the plumbing field for more than a decade now; certainly the best experience for your plumbing repair needs. Contact us today for plumbing in Little Rock.

No comments yet.

Leave a Reply

501-225-3200